1 3

Rolling Wrench

LED Adjustable Flasher Unit (Hyper Flash Fix)

LED Adjustable Flasher Unit (Hyper Flash Fix)

$6.50 USD
$15.00 USD $6.50 USD
Sale Sold out
Shipping calculated at checkout.

Swapped to LED turn signals and now your blinkers are going hyper-speed (or barely flashing at all)? This adjustable 2-pin flasher unit fixes that. Just plug it in where your stock flasher lived, dial in the blink rate you like, and enjoy properly working signals again — no hot resistors, no wiring science project.

The Details ▶
When you upgrade to LED turn signals, the stock flasher usually freaks out because it’s designed around the load of old-school filament bulbs. This adjustable unit is built to play nice with LEDs.

What it does:
  • Replaces your stock 2-pin flasher module
  • Corrects hyper-flash or super-slow flash issues caused by LED signals
  • Lets you fine-tune flash speed with a built-in adjustment dial
  • Eliminates the need for big, hot load resistors
Why this is better than resistors:
  • No extra wiring hanging off your harness
  • No resistors getting “a million degrees” and cooking nearby parts
  • Cleaner install and easier to change later

The adjustment knob is fragile — it works great, just turn it gently when dialing in your preferred flash speed.

Important Things to Note ▶

Unit only – no wires included. This is the flasher module itself. You’ll reuse your existing 2-pin connector or wiring.

Designed for 2-lead flasher setups. Make sure your bike uses a 2-pin flasher before ordering — if you have a 3-pin style, this won’t be plug-and-play.

When adjusting the dial, turn it lightly and slowly. Cranking on it too hard can damage the adjustment mechanism.

 

View full details